SEKURE DGP2-648 Uživatelský manuál stáhnout pdf (Strana 23)

Digiplex 848/DigiplexNE LED Keypads 21n

How do I program a user access code?

1) Enter your [System Master Code] or [Access Code] with

Master feature.

2) Press the [0] key to enter the User Programming Menu. The area

lights of areas assigned to your User Access Code and the P

action light will flash.

3) Press the [Acc] key. The area lights of the areas assigned to

your User Access Code and the A

CCESS action light will

illuminate. The P

RG action light will continue to flash.

4) Enter either a 2-digit User Number (02 to 96 for a Digiplex 848

system) or a 3-digit number (002 to 999 for a DigiplexNE system)

you wish to program. The A

CCESS action light will flash for an

unused code. If the code is used, P

RG action light and the first

number of the code will illuminate. The A

CCESS action and area

light will turn off.

5) Enter a User Code. If you do not want to change an existing one,

press the

[U] key until you reach User Options. Your keypad will

emit a Half Beep when it switches to User Options. Pre-existing

options will illuminate.

6) Program the User Options (Table 1 on page 22) by turning the

options “ON” or “OFF”. Once the options are programmed, press

the

[U] key to reach the Area Assignment. Your keypad will emit

a Half Beep when it switches to Area Assignment. Pre-existing

assignments will illuminate.

7) Program the Area Assignment (Table 2 on page 25). Press the

[V] key to return to User Options or press [Enter] to save and

exit. Your keypad will emit a Confirmation Beep to confirm the

code’s acceptance.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Žádné komentáře

SEKURE DGP2-648 Uživatelský manuál Strana 23