SEKURE SX-3100LCD Návod k obsluze Strana 338

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 378
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 337
326 GAS ANALYZER
4. Insert the probe at least 12" into the tailpipe of the vehicle.
Insert the end of the sampling probe a minimum of 12" into the tailpipe of the vehicle.
The sampling probe comes with two types of retainers to ensure that the probe stays
inside the pipe during use. Once the probe is inserted, use the chain to secure tailpipe
probe during the road test.
5. Route and secure the sampling, exhaust, and drain hoses out of the vehicle.
Take up the slack of the remaining hose outside of the vehicle by rolling up the excess
and placing it inside. Secure the hoses in place without pinching them. Make certain
that the exhaust and drain hoses are routed outside of the vehicle to avoid the risk of
exhaust fumes blowing back inside.
FLEX-HOSE
PXA-100
EXHAUST
PROBE
TESTER
SECURE CHAIN
SAMPLING,
EXHAUST,
AND DRAIN
HOSE OUTLETS
FIGURE 9. Inserting the Sampling Hose into the Tailpipe for Road Testing
WARNING!
Carbon monoxide gas is poisonous. Vent Gas Analyzer exhaust
hose and vehicle tailpipe to the outside.
WARNING!
Once the analyzer samples the gas, it deposits the sample
through the exhaust and drain hoses of the analyzer sampling
hose assembly. It is important that this exhaust is treated the
same as the exhaust coming out of the vehicle’s tailpipe.
Therefore, proper routing of the hoses is required for ventilation
of the exhaust and drain.
Zobrazit stránku 337
1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 377 378

Komentáře k této Příručce

Žádné komentáře