SEKURE Paradox Spectra 1686H Instalační manuál stáhnout pdf (Strana 35)

SPECTRA SERIES 33

8.4 PARTITION ACCOUNT NUMBERS

Section [143] = Partition 1, [144] = Partition 2

All report codes are preceded by a 4-digit or 3-digit Partition Account Number to ensure correct identification in a

partitioned system. Partition account numbers can be any hexa-digit from 1 to F. To enter a 3-digit account number,

simply press the [FORCE] key followed by the 3-digit account number. Also, when using 3-digit account numbers, you

must use 1-digit report codes.

8.5 REPORTING FORMATS

Section [140]: 1st digit = Format for Phone #1, 2nd digit = Format for Phone #2

The Spectra Control Panels can use a number of different reporting formats and each Central Station Telephone

Number can be programmed with a different reporting format. The first digit entered into section [140] represents the

reporting for mat used to communicate with Central Station Tel ephone Number 1, the second digit represents the

reporting format used to communicate with Central Station Telephone Number 2. The Backup Telephone Number uses

the same reporting format as the last Central Station Telephone Number that was dialed. UL Note: The installer is

required to verify the complete compatibility of the DAC Receiver and formats at least once per year.

If Hexadecimals (0 to FF) are used to p rogram the report codes, verify that the pager also supports

Hexadecimals. If the pager does not support Hexadecimals, use only the digits 0 to 9.

8.5.1 STA NDA RD PULSE FORMATS

The Spectra Control Panels can use the Ademco slow, Silent Knight and Sescoa standard pulse reporting

formats (see Table 8).

8.5.2 ADEMC O EXPRESS

The Ademco Express is a high-speed reporting format, which will transmit the 2-digit (11 to FF) report

codes programmed into sections [160] to [213]. Unlike other Ademco formats, the Ademco Express does

not use the Contact ID Report Codes.

8.5.3 ADEMC O CON TAC T ID

Ademco Contact ID is a fast communicator format that uses tone reporting instead of pulse repor ting. This

communicator format also uses a pre-defined list of industry standard messages and report codes that will

suit most of your basic installation needs. Please refer to the Contact ID Report Codes List in the

Programming Gui de for a complete list of these repor t codes and messages.

Table 7:

Special Keys for Telephone Numbers

Press Action or Valu e

[STAY] *

[BYP] #

[MEM] switch from pulse to tone dialing or vice versa

[TBL] or [TRBL] 4-second pause

[FORCE] deletes current digit

[PG] or [ FNC1] inserts blank space

Table 8:

Reporting Formats

Value Entered Reporting Format

1 Ademco Slow (1400Hz, 1900Hz, 10BPS)

2 Si lent Knight Fast (1400Hz, 1900H z, 10BPS)

3 SESCOA (2300Hz, 1800Hz, 20BPS)

4 Ademco Express (DTMF 4+2)

5 (Default) Ademco Contact ID

6 Pager Format

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Komentáře k této Příručce

Žádné komentáře

SEKURE Paradox Spectra 1686H Instalační manuál Strana 35

Komentáře k této Příručce