SEKURE DGP2-641 Instalační manuál stáhnout pdf (Strana 28)

26 R

EFERENCE

& I

NSTALLATION

ANUAL

8.5.1 Tamper Bypass Options

(Default = enabled) With option [7] enabled in section [3034], the control

panel will ignore the zone’s bypass definition and will follow the option set in

section 8.5 if a tamper or wire fault occurs on a bypassed zone. With option

[7] disabled, Tamper Recognition follows the zone’s bypass definition. This

means that the control panel will not perform any action if a tamper or wire

fault occurs on a bypassed zone.

8.6 K

EYPAD

ANIC

PTIONS

(Default = disabled) The control panel can generate an alarm (silent or

audible) when two keys are pressed and held simultaneously for 2

seconds. In the section that corresponds to the desired partition, enable or

disable options [1] through [6] as desired:

ILENT

LARM

The control panel emits a single Confirmation Beep and transmits the

appropriate report code (see section 9.2.10).

UDIBLE

LARM

The control panel activates the

BELL

output until a user cancels the alarm

with a valid User Access Code or when the Bell Cut-Off Timer elapses (see

section 8.2).

IRE

LARM

Same as audible operation, except that the bell/siren output will be pulsed

as shown in Figure 5-4 on page 18.

Partition 1: [3123] Partition 3: [3323] Partition 5: [3523] Partition 7: [3723]

Partition 2: [3223] Partition 4: [3423] Partition 6: [3623] Partition 8: [3823]

Option Feature Press and Hold:

[1] Panic 1 Keys [1] and [3]

[2] Panic 2 Keys [4] and [6]

[3] Panic 3 Keys [7] and [9]

Option Alarm Type

[4] Panic 1:

= Audible

OFF

= Silent

[5] Panic 2:

= Audible

OFF

= Silent

[6] Panic 3:

= Fire

OFF

= Silent

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 65 66

Komentáře k této Příručce

Žádné komentáře

SEKURE DGP2-641 Instalační manuál Strana 28

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu SEKURE DGP2-641