SEKURE DGP2-641 Instalační manuál stáhnout pdf (Strana 40)

38 R

EFERENCE

& I

NSTALLATION

ANUAL

13.1 I

NSTALLER

ODE

(Default: 000000) The Installer Code is used to enter the control panel's

programming mode, which allows you to program all the features, options

and commands of the control panel and any modules on the

communication network. The Installer Code is six digits in length where

each digit can be any value from 0 to 9. To change the Installer Code:

1) Press and hold [0]

2) Enter [

INSTALLER

CODE

]

3) Key in [1000]

4) Enter new 6-digit [

INSTALLER

CODE

]

The Installer Code can program the User Code Options and the

Partition Assignment, but cannot program the personal

identification numbers.

13.2 A

CCESS

ODE

ENGTH

Access codes can be 1 to 6 digits in length. When programming access

codes with less than 6 digits, press the [

ENTER

] key after entering the last

digit. The control panel automatically removes the last 2 digits of the User

Access Code if the length is changed from 6 digits to 4 digits. However, if

the User Access Code Length is changed from 4 digits to 6 digits, the

control panel adds 2 digits to the end by using the first 2 digits.

For example, if the User Access Code is 1234 and you switch to 6 digits,

the code will become 123412.

13.3 S

YSTEM

ASTER

ODE

(Default: 123456) The Installer Code can change the User Code Options,

Partition Assignment and Access Control Options, but cannot change the

personal identification number (PIN). Each digit in the System Master Code

can be any value from 0 to 9. To reset the System Master Code, refer to

section 12.2 on page 35. With the System Master Code, a user can use any

of the available arming methods with access to all partitions and can

program all User Access Codes, User Options, Partition Assignments and

Access Control Options.

13.4 P

ROGRAMMING

CCESS

ODES

(Default = all options are off) The control panel supports 998 User Access

Codes. In sections [1002] to [1999], the Installer Code can program the

User Code Options, Partition Assignment and Access Control Options, but

cannot program the personal identification numbers (PIN). To program the

PINs, refer the users to the System Manager’s Manual. The System Master

Code or a user with the Master feature enabled can program the User Code

Options, Partition Assignment, Access Control Options and User Labels

using a different method of programming.

If no partition assignment is selected, the User Access Code will

only be able to activate PGMs.

Figure 13-1: Programming User Access Codes

13.5 U

SER

PTIONS

The User Options define how each User Access Code can arm or disarm

the partitions. All users can Regular Arm (see section 16.1) their assigned

partitions, but only those with the Disarm option enabled can disarm an

assigned partition.

Option Description

[2] [3]

OFF OFF

4-digit User Access Code (Default)

OFF ON

6-digit User Access Code

ON ON

Flexible User Access Code

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 65 66

Komentáře k této Příručce

Žádné komentáře

SEKURE DGP2-641 Instalační manuál Strana 40

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu SEKURE DGP2-641